Regent

REGENT

These are special floor covering embedded with Silicon Carbide (Corundum) grains on the top surface which provide very high slip resistance rating. Due to a superior PVC content and Silicon Carbide Grains, Traction flooring is able to withstand very high abrasion and are most suitable for areas where there is heavy footfalls and anti-slip properties are required like Buses, Trains, Ramps, Wet Areas, etc.

Regent is normally produced with a smooth surface finish, however for enhanced slip resistance they are produced with an embossed surface finish from our “Matrix” range. For aesthetic properties these flooring are also embedded with multi coloured Polymer chips.

Salient Features:

  • Produced as per ISO requirements and with Fire & Smoke emission requirements which are most important for the transport industry
  • Product is “T” rated due to it very high abrasion resistance properties
  • Slip Resistance of R11 or R12 can be achieved depending upon the top embossing selected
  • Available in Plain colours or with Multi Coloured Chips
  • Also Available with Glass Scrim Reinforcement for very high Dimensional Stability
  • Application Areas: Transport sector like Buses, Trains, Lifts, Loading Ramps,Walk ways, Wet Areas, etc

Specifications:

  • Thickness: 1.2 mm, 2 mm, 3 mm
  • Roll Width: 2 linear mtr
  • Roll Length: 15 linear mtr

Maintenance

Please read the following instructions carefully

Do’s: 

  • After laying of flooring, the surface should be clean daily with damp mop and weekly or fortnightly with soap solution.
  • Prevent point load indentation by covering your furniture legs with rubber stopper caps
  • To remove stubborn stains, rub the affected area immediately with a soft coir brush or fine steel wool soaked in a warm soap solution
  • Scuff marks on the floor can be removed with little application of diesel
  • Use door coir or suitable mats to minimize accumulation of dust on Gem flooring
  • Use water to remove any chemical spill on flooring

Don’ts: 

  • Do not use any strong detergent, harsh cleaning agent or dry steel wool
  • Throwing of lighted cigarette butts or match sticks on the floor should be avoided as it could lead to burn marks on the floor
  • Do not drag any heavy object or furniture on the flooring to avoid scratches on the floor

Recommendations

Installation:

 Regent sheet must be allowed to relax for 24 hours in room temperature between 18°C and 27° C prior to installation. Vinyl flooring is suitable for laying on any surface such as concrete, steel, wooden floors etc. provided the sub-floor is even, hard and dry. Damp floors should be dried before the commencement of laying. Before installation, the base floor must be thoroughly clean, dry and free from grease and grit. Regent recommends use of Gem Adhesive or any other equivalent rubber/acrylic based adhesive of similar type.

Available Shades

EC-GREY-1

N-BLUE-1

SR-BEIGE-1

TERRACOTTA-1